Weston 08-3201-W Manual de Instruções descarregar pdf (Página 12)

WARNING! Before cleaning, assembling or disassembling the Grinder,

make sure the PLUG IS REMOVED FROM THE OUTLET/POWER SOURCE!

ALWAYS unplug the Grinder when not in use.

STANDARD STUFFER

ASSEMBLY INSTRUCTIONS

1. Insert the Head into the Gear Housing

with the feed chute of the Head facing straight

up. You will need to line up the slot in the

Head with the Pin inside the Gear Housing.

Be sure the Head is seated fully into the Gear

Housing

(Figure 6).

2. Tighten the Head Locking Knob to lock

the Head into place.

3. Insert the Auger, with the Auger Bearing

attached, into the Head

(Figure 7). Align the

Auger Splines with the Drive Shaft of the

Grinder.

NOTE: Periodically inspect the Auger

Bearing for wear. If the Auger Bearing is

worn excessively, replace it immediately or

Head damage could result.

4. Slide the Stufng Star over the

round portion of the Auger Pin.

5. Slide one of the Stufng Funnels

through the Flange and place it

through the Front Ring Nut.

6. Install the Front Ring Nut, DO

NOT OVERTIGHTEN. Turn the

Front Ring Nut until it makes contact

with the Flange, then make 1/4 turn

more to tighten into place.

...INSTRUCTIONS CONTINUED ON NEXT PAGE

FIGURE 7

Head

Auger Bearing

Auger

Auger Splines

Auger Pin

Front Ring

Nut

Flange

7. Insert the neck of the Tray into the Feed

Chute

(Figure 8).

8. NEVER operate Grinder without the Tray

secured in place

(Figure 9).

REFER TO “STUFFING INSTRUCTIONS”

FIGURE 8

Tray

Head

FIGURE 9

Tray

-12- -13-

Feed

Chute

Neck

NEVER operate Grinder without the

Tray secured in place.

To avoid serious or fatal injury, NEVER reach

into any Grinder inlet.

ALWAYS use the Stomper to push meat

into the Grinder Head.

Read & fully understand all instructions

& warnings prior to use.

WARNING!

NEVER operate Grinder without the

Tray secured in place.

To avoid serious or fatal injury, NEVER reach

into any Grinder inlet.

ALWAYS use the Stomper to push meat

into the Grinder Head.

Read & fully understand all instructions

& warnings prior to use.

WARNING!

Gear

Housing

Head

Slot in Head

FIGURE 6

Head Locking

Knob

Feed

Chute

1 2 ... 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários

Weston 08-3201-W Manual de Instruções Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Picadoras Weston 08-3201-W